This package is recommended for street stock, limited late model, modifides and limited sprint car classes using Holly 4412 check legal 2bbl carburetor rules and 200cc or less head intake runner rules.

It is recommended that each track and/or series should purchase from Schwanke Engines one computer to be used for random rotation among competitors. The atmosphere of a competitor knowing he or she may not always take the same computer home they came with is the most important tech procedure. This will help eliminate any need for internal inspection.

There are four seals on the engine:

One on each center of the valve cover

One on the timing cover right side below water pump

One on the right front corner of the intake manifold

The seal numbers are sequential. Five seals are produced for each engine one is held back for teching and/or field service available by paper trail, tech and the race director signatures. You then need to call Schwanke Engines for the seal. (Example number 530001 = 53 represents 5300 truck engine and 0001 is serial number).

3) Scanner Test:

The system also features a 16 pin OBD II ALDL connector a Tech II or Snap on Tools scanner can be used to access data stream. Call Schwanke Engines for VIN information.

Mass air flow sensor GM 25168491

Injector 25323974, 25317669 and 2517628

75mm (2.950-2.965) Stock throttle body GM cable drive only

Head casting 862 or 706

Block casting 12551358

Cranking compression 155-165lbs

Base idle 1200rpm

Fuel pressure 58-62PSI wide open throttle