525HP Sealed Engine Program

500 Ft-LBS Torque

Rating based on 94 Octane Unleaded Gas

(6975 Rev. Limit)

   · 6.0L Cast Iron Block Assembly and LS2 Heads
   · PCM & Custom Wiring Harness
   · Low Oil Pressure & Overheat Protection
   · 600 Lift Hydraulic Roller Cam
   · ATI Super Damper
   · Water Pump (#16 Outlet)
   · 85 Amp Alternator
   · Steel Dry Sump Oil Pan
   · 75mm Throttle Body
   · Barnes Scavenge Pump
   · KRC Power Steering Pump
   · Front Motor Mounts
   · In Tank Electric Fuel Pump Kit
   · Inline Fuel Filter
   · Serpentine Belt Drive
   · Mass Air Flow Sensor
   · Throttle Cable
   · 1 3/4" Cross Over Headers
   · Installation Instructions
   · Limited Warranty

$11,999.99 + Freight

LS2 Aluminum block option add $999.00

Requires GM 2000 and later crankshaft bolt pattern. Bert transmission hubs and clutch backup plates available to retrofit your existing transmission or clutch (not included in this package).

Sealed Engine Warranty Policy:

Subject to inspection all generation III sealed engines up built by Schwanke Engines will carry a Limited 30 day race warranty from the date of beginning of season or purchase date Warranty covers catastrophic failure of sealed assembly only.  Does not cover bolt on Accessories, Harness, Injectors etc. ...  Overheat tabs, altered seals, PCM tampering, under hood fires, improper maintenance, severe impact or blatant misuse will void all warranties.

Optional Rebuild Program:

You can send your engine back to Schwanke Engines and have the engine renewed after 1 season of service for $4,699.99 + freight. Parts include rod and piston upgrade to aftermarket parts this is for earlier engine designs prior to 2/23/08. Rings, bearings, gaskets, valves, valve springs, valve seals, dyno test and reseal engine. If the engine is already equipped with aftermarket rods and pistons price is $3,999.99 specify seal #.